Welcome to Tesselator


LCD Menus
	This section describes each LCD menu screen. The main menu displays the pan and tilt positions (in degrees) on the top line of the display. Pan is on the left and tilt on the right. The current camera frame is displayed on the bottom right. The numbers to the left of the screen headings are shortcuts to that heading. For instance, press ‘1’ to display the ‘GO TO’ screen.
	Go to:
	Start:
		Sends pan and tilt to their start positions as defined on the Tess page. This defaults to zero for each axis on power-up.
	Grid#:
		This is the move preview page. The head can be sent to any selected grid number. Enter a grid number for both pan and tilt, when you press 3, both pan and tilt will go to that grid position. Press 4, and the head will immediately move to the previous grid number. 5 will move the head to the next grid position. 8 will shoot a camera frame. The arrow buttons will also move the head 1 grid at a time, in all 4 directions. So you can ‘walk’ or browse through a move, shooting film only if required.
	Pos:
		Sends pan or tilt to the selected position. Enter a position in degrees for pan or tilt and that axis will move to that position.
	Zero:
		Sends both pan and tilt to position ’0.00’.
	Preset:
		Each number from 4 through 9 refers to a preset position for both pan and tilt. Just press any number and both pan and tilt will slew to that position. See below (Set Preset).
	Set:
	Start:
		Sets the current position for both pan and tilt as the start position for the tiling move. This refers to 1 corner of the grid if the grid is Corner based, or the center grid if Center based. See below (More Tesselator Config).
	Position:
		Resets the current position for pan or tilt to any number.
	Zero:
		Resets both pan and tilt to position ‘0.00’.
	Preset:
		Each number from 4 through 9 refers to a preset position for both pan and tilt. Just press any number and that memory location will store the current position for pan and tilt. These positions are saved with a move.



		Back to index

LCD Menus

Go to:

Start:

Sends pan and tilt to their start positions as defined on the Tess page. This defaults to zero for each axis on power-up.

Grid#:

Pos:

Sends pan or tilt to the selected position. Enter a position in degrees for pan or tilt and that axis will move to that position.

Zero:

Sends both pan and tilt to position ’0.00’.

Preset:

Each number from 4 through 9 refers to a preset position for both pan and tilt. Just press any number and both pan and tilt will slew to that position. See below (Set Preset).

Set:

Start:

Sets the current position for both pan and tilt as the start position for the tiling move. This refers to 1 corner of the grid if the grid is Corner based, or the center grid if Center based. See below (More Tesselator Config).

Position:

Resets the current position for pan or tilt to any number.

Zero:

Resets both pan and tilt to position ‘0.00’.

Preset:

Each number from 4 through 9 refers to a preset position for both pan and tilt. Just press any number and that memory location will store the current position for pan and tilt. These positions are saved with a move.

Back to index